Write a ladder logic program for slc 500

#WRITE A LADDER LOGIC PROGRAM FOR SLC 500 GENERATOR#

For example, a simple machine with just a cylinder. What he means by that is based on the logic you have written if the inputs do not conform to what you want them to be, then the plc (based on the logic written) will change outputs to make the inputs conform. JW, what you heard about the plc using the outputs to control the inputs is from Bernie Carlton's sig line.

#WRITE A LADDER LOGIC PROGRAM FOR SLC 500 GENERATOR#

I always use a PLC based ramp generator as well for coordinated, multi-motor systems, never the ramps built into the drives, but once written, it's pretty much done forever. When all sections are done, you just have to tie the 'whole line' parts in, which is usually almost complete by then. The final part of each section is the analog or reference logic. What must be satisfied to allow this section to run in coordinated mode? to run in independent mode? to jog? After the interlocks are done, I do my main logic sequencing. Only after that is done do I bother writing the code, and just to keep things consistent in my head, I start with interlock logic. Then I make a list of all inputs and outputs associated with that section, and write down how each of them should affect the machine section and when. I start by breaking a machine down into logical sections, and writing down exactly what that section is supposed to do and when.Дoes it run in speed mode? torque mode? position mode? Does it need to jog? forward/reverse?

Write a ladder logic program for slc 500